Posted by redforlife on January 11, 2022 at 17:09:04 from (68.234.121.189):
In Reply to: Fixing an oil leak posted by Mtjohnso on January 11, 2022 at 15:47:31:
You should not be installing this by driving it in with an extension. That is your problem. There is a special tool that is used for driving in freeze plugs. Your oil plug is essentially the same thing as a freeze plug. The tool has a mushroomed head on it that matches up to the inside of the freeze plug. Different sizes to match up to the various sizes of freeze plugs. This makes the outer edge of the freeze plug taper in as it is being driven into the hole. Hitting it in the middle with an extension will cause it to bend other than just at the outer edge. It'll cause the plug to bend in the middle, and pull the outer edge in at 2 points, and not evenly all the way around.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Generators - by Chris Pratt. As a companion to the articles on three-brush and two-brush generators, it seemed fitting that we should provide our readers with a description of how a generator works in lay terms. The difficulty with all those "theory of operation" texts is that they border on principles of electricity or physics and such. Since I know nothing of either, you will have to put up with looking at the common sense side of how generators work which means we "
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
