Posted by Fritz Maurer on January 11, 2022 at 07:43:58 from (174.207.96.162):
In Reply to: Farmall Super MTA posted by GT129 on January 10, 2022 at 20:06:33:
Regarding the air filter, if it is clear enough for it to run without choking the engine, I would just try filling it with oil and trying it for awhile. As B-Y says, they have a tendency to clean themselves when at rest, as the oil drips out of the media it carries the dirt with it. The reason it is like that to begin with, is going for years without servicing; all the oil has left the cup through the form of vapor, leaving the system dry. With no oil dripping from the media, the dirt just stays there. If your filter is too far gone, drill out the spot welds and remove the bottom retainer. Unless the media is damaged or rusty, there is no reason to replace it. Just unwind it and lay it out flat , and run it through a shallow pan of hot water and Dawn detergent. Do not be concerned about every last spec, as the action of the air cleaner will take care of any minute pieces.To get it back in the housing, find a piece of PVC the same size or slightly larger than the center tube. Wind the media around the tube, rather tightly, and it can be easily inserted into the housing. You do not even need to re-weld the retainer, you will find it just snaps back into place and nothing more need be done with it.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Self-Starting Tractor - McCormick 10-20 - by Francis J. Robinson. I remember it very clearly even though it was almost 50 years ago and I was only about seven years old. My Dad had purchased a new Ford-Ferguson tractor and basic set of implements when he started farming just about the beginning of W.W.II. It was considered a pretty nice outfit for their 70 acre central Indiana grain and livestock farm. Dad spent several years during the war testing aircraft engines at Allison Engineering in Indianapolis working seven days a week on a twelve hour night sh
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
