Posted by Bill(Wis) on December 28, 2021 at 07:40:01 from (67.86.36.109):
In Reply to: stumps posted by Ellis Kinney on December 28, 2021 at 07:26:34:
Can you just cut the stump flush with the ground and just leave it? I had a big maple tree that had to come down because it was too close to where I built my new shed. The stump ended up about 10 feet from the access door to the shed and right along side the walkway to the shed. I cut the stump off flush with the ground and put an oak barrel planter on it and filled it with flowers every summer. Now, 13 years later, the stump is gone. If that's not suitable, some people have told me that drilling holes in the stump and applying salt works well. Another good way to do it, which I do a lot of, is to burn them. Sometimes I place a 55 gal barrel with both ends cut out over the top of the stump and soak the stump with my old waste oil and torch it. Also burn a lot of other stuff that way which can be done at the same time.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Sunday Drives - by Cowboy. Summer was finally upon us here in Northern Maine. We have two types of industry up here, one being "Forestry" (Wood Products) and the other "Farming" (Potatoes). There is no shortage of farm tractors and equipment around here! I have been restoring old Farm Tractors for the past 6 years, and have found it easier and less expensive to hit all the auctions and purchase whole tractors for parts needed. My wife who works at a local school, and only has weekends and summers off, while on t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
