Posted by Jim.ME on November 10, 2021 at 10:52:31 from (67.242.178.40):
In Reply to: distributor dust cover posted by billjonkey on November 10, 2021 at 10:39:24:
Quote: CVPost-billjonkey (quoted from post at 14:39:24 11/10/21) I have a Ford 861 Powermaster tractor with ignition problems. After removing the distributor cap, I find I cannot remove the dust cover to access the rotor.
CAN ANYONE PROVIDE ME WITH THE TRICK TO REMOVING THE DUST COVER?
Thanks, Bill
The rotor (#2) is above the dust cover and gets removed after the distributor cap, then the spring clip (#38) the rotor was slid over. After removing the spring clip the dust cover(#34) should come off. If it is stuck a bit of gentle prying around the edge to free the gasket may be needed.
This post was edited by Jim.ME on 11/10/2021 at 10:54 am.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Search For Spares - by Anthony West (UK). Following on from the aquisition of the old Fordson F, I was very much in need of spares. As a novice though I didn't appreciate the fact that there were so many Fordson tractors made, that all the other makes seem rare by comparison. As far as I was aware a fordson was a fordson and it was only through trial an
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
