Quote: CVPost-Martin Seebach (quoted from post at 17:54:04 11/02/21) So far I've kinked neck, had pry bar nail both hands, slipped in mud and conked forehead on rim... Then a buddy tried helping and about 20 mins later his hand was in the way of fast moving 4' tire tool. There has got to be a way to get the tire outside rim back over the rim metal edge without tearing new tube or bead part of tire. Open to suggestions, funny sarcasm and would prefer not to spend 350 dollars or more for a 3 minute task. I haven't tried the rock breaker digging bar, yet. It is on a JD industrial loader with a gannon scraper/ripper box on back.
On or off the tractor? Front or rear, size, and pictures of how you are going at it would help. first bead or one on and going after the second bead?
Most rims have a narrow and wider side beside the dropped center. Tire should go on from the narrow side so the bead can drop into the center. What are you using for lube? the right tire irons can make a difference.
This post was edited by Jim.ME on 11/02/2021 at 03:05 pm.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Sunday Drives - by Cowboy. Summer was finally upon us here in Northern Maine. We have two types of industry up here, one being "Forestry" (Wood Products) and the other "Farming" (Potatoes). There is no shortage of farm tractors and equipment around here! I have been restoring old Farm Tractors for the past 6 years, and have found it easier and less expensive to hit all the auctions and purchase whole tractors for parts needed. My wife who works at a local school, and only has weekends and summers off, while on t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
