The Ann Arbor Agricultural Machine Company was founded in 1885. It became the leading manufacturer of "hay presses" or stationary balers, and was acquired by the Oliver Farm Equipment Company in 1943.
The 'Ann Arbor Agricultural Machine Company' is not quite the name of the Ann Arbor born company that Oliver acquired in 1943. The original company was set up by Lewis Moore in 1866 (there is a suggestion it was actually in 1865) as L. Moore and Son. The company made small farm implements. In 1870, Eli Moore, John Finnigan and a Mr. Howard bought into the company with the name changing to the 'Ann Arbor Agricultural Company'. The first Hay Presses (named, 'Advance Hay Presses') built by the company, were built probably in 1889 although it is possible individual examples were built as early as 1887. This company name lasted until 1903 when a reorganisation had it renamed, the 'Ann Arbor Machine Company'.
The 'Ann Arbor Machine Company' name persisted until 1920 when it was changed to the 'Ann Arbor Baler Corporation'; the company was incorporated back in 1878! The company went into liquidation in the latter half of 1920 and was sold at Public Auction on November 30 of that year. The entire company, all its patents, its capital assets, the whole lot, was bought by The Tallman family of Shelbyville, Illinois. The Tallman's changed the company's name back to the 'Ann Arbor Machine Company' but moved it to Shelbyville in January of 1923.
The Tallman's sold it to Oliver in 1943, leading to 'Oliver Ann Arbor' Balers being on the market between 1943 and 1949 when the Ann Arbor name disappeared.
This information was found by googling Ann Arbor Bailer
This post was edited by Rodney51Cub on 10/27/2021 at 06:39 pm.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
