Sure he could have approached the project differently but like the saying goes you never forget what you learn from a hard lesson.
I am sure there are more than a few of us here that started fixing and wrenching on equipment long before the internet was invented.
You only had a few options back then;
-Make a guess of what or where the problem was and dig in.
-Pay someone to fix it if you had any money.
-Go to a library and maybe find a shop manual for something similar then copy down what you read because they would not loan out reference material.
The first time I tore apart an automatic transmission the only specialty tools I had were a broomstick and a piece of plywood.
No manual, no mentor, no money and a blown transmission in my truck.
I found a used car transmission with a broken case that I bought for $30, I knew it would not fit my 4x4 but I knew most of the guts were the same.
Took them both apart laying everything out on the broomstick and sheet of plywood as I did not have the knowledge or a book to show me what goes where.
Spent a whole day transferring the guts into my case and low and behold I had a truck to drive to work by Monday morning.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.