Posted by TomA in CA on October 12, 2021 at 13:28:01 from (76.9.70.50):
The power went off this morning at 5:30 am. The PG&E sends us messages quite often that there might be a Public safety power shut off. Most times it never happens. Today there was no warning. It will be off about 10 hours. Actually it was only turned off once before a few months back. It took a while to get the generator up and running. I forgot to turn the gas back on. Supposedly it is due to high winds. Well it is far less windy here today than it was yesterday. I guess it is windy some place so they turned it off.
Whenever they turn it off they have to send a helicopter out to check all the lines before they can turn it on again. A while ago I was outside and a huge Bell helicopter was cruzing around checking the lines. It went over so low that it was blowing leaves all over, that was the most wind we have had in the last 24 hours. They are going to raise our rates to pay for all the tree trimming and the helicopter. It must cost a lot of money to hire a helicopter like that. Well it came back on while I was writing this. It is about 1:30 now so it was only off 8 hours.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Product Review: JB Weld - by Staff. JB Weld is basically an epoxy glue that does an exceptionally good job of bonding to cast iron and steel along with several other materials. As I mentioned, it is so common that I have yet to buy a tractor that did not have JB Weld used somewhere. It is sometimes used so well you can't tell its there and other times used as a sloppy quick fix. Finding where and how it can be used correctly is key to whether you are using it as an "inelegant hack" or an integral solution to difficult and expens
... [Read Article]
Latest Ad:
WANTED Front grille/nose assembly for Massey Ferguson 1160 (also fits 1180 & 1190). Headlight-mount section. AGCO Grille 3706022M91 (supersedes 3705942M91), cover 3705494M1/M2, holders 3705501M91/3711158M92. New/NOS/good used OK. Jonesboro, AR - will pay shipping. Photo appreciated. Thanks
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
