Posted by rustcollector on October 11, 2021 at 15:30:14 from (99.197.4.253):
In Reply to: Re: Farmall H posted by Janicholson on October 11, 2021 at 10:34:21:
Agree with JAN in theory but my experience with H's and M's with cotton pickers is a bit different. Either tractor with a single front will steer easier than with a two wheeled tricycle front (unless on a flat surface)when cultivating, spraying or with cotton picker. Put a single sweep in the center of the row-middle when cultivating and the single tired tractor will follow the furrow with very little effort and without fighting for the furrow. Put a ridge in the row-middle and the double wheels work OK for cultivating or cotton picker but will fight in a sharper turn. Sitting still, the single wheel will be hard to turn but move it an inch or two and all the tire turning is overcome by the caster effect. Make sure the caster is to the rear of the direction of travel and the stop bolt is in the proper position. Cotton pickers need weight on the steering tire to counter-balance the row unit, but will add perhaps up to 800 to 1000 lbs as the basket fills. I have never seen a cotton picker without a single wheel steering unless it had power steering on the tractor or a wide steering axle. Not many H's or M's had power steering from the factory. As others have said, good bushings and thrust bearing on the bolster, good U joints and bearing on the steering shaft with a good or less worn top gear and all will be good. Not all top gears are 360 degree gears. Wheel bearings are more difficult to change, but dealing with only one tire to purchase with single wheel. Some will argue that you can limp home with a dual tricycle with one flat or wheel bearing gone bad, but don't count on going very far.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Usin Your Implements: Bucket Loader - by Curtis Von Fange. Introduction: Dad was raised during the depression years of the thirties. As a kid he worked part time on a farm in Kansas doing many of the manual chores. Some of the more successful farmers of that day had a new time saving device called a tractor. It increased the farm productivity and, in general, made life easier because more work could be done with this 'mechanical beast'. My dad dreamed that some day he would have his own tractor with every implement he could get. When he rea
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
