Posted by Geo-TH,In on October 09, 2021 at 06:43:03 from (50.102.24.136):
In Reply to: Re: Home HVAC unit posted by MarkB_MI on October 09, 2021 at 03:32:35:
Mark, How are split units better than window shakers beside being quiet? Before split units, I've seen people cut a hole in wall and install window AC's Another option are units like used in motels. I know a man who has 3 of these units in his insulated pole barn. Those units can be pulled out and taken outside an sanitized.
I think the biggest issue is pulling water off the evaporator causing a health issue, black mold.
I think you mentioned the biggest disadvantage too, only cooling a few rooms. Same will apply to heat pumps.
My brick house was built in 1942, I remolded in 1991. In 1942 the duct work ran both a hot air and return air in each room. You can close a door and room temp doesn't change. All my rooms are at the same temp because of a cold air and return air in each room. My bigger rooms I have 2 of each. Today's standards, you one or 2 large cold air returns, close a door and you are in trouble heating and cooling..
Without proper air circulation no cooling system will work well. Just my opinion.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Torque Wrenches - by Curtis Von Fange. When working with fasteners a torque wrench can play an important role in the correct assembly of critical equipment components. Lets examine in detail some of the reasons for using a torque wrench along with how to correctly use the variety of wrenches available. Applying the proper torque to a fastener accomplishes a number of tasks. First of all correct torque will hold the parts together. This may seem like a trite statement but � think about it for a second. Engineers have designed
... [Read Article]
Latest Ad:
WANTED IH C200 gas engine — complete running motor Wanted complete used IH C200 gas engine in running condition for an International 574 gas tractor. My block has a hole in it and is dead, so a rebuild kit wont do it — need a whole running motor. The C200 also came in the 544 and 674 gas trac
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
