Coming from a farm in Wisconsin that was in the business of dairy farming for over 70 years, I never heard of anyone feeding whole corn kernals to dairy cows. The dried corn (in our case, as with neighbors, this was always dried corn on the cob) was always run through a mill. Hammer mills almost exclusively. In those years a coarse grind was specified for cows but this pretty well pulverized the corn. Fine grind (achieved by simply changing screens in the mill) was reserved for pigs and chickens. But, nevertheless, the corn for dairy and beef cows was well pulverized for feeding. This was usually combined with oats and other additives to include wheat bran, miller's grains, soybean oil meal, minerals, etc. Somtimes feeds employing molasses and beet pulp were added. Most notably Purina Bulky Las. All of these thing were fed with good effect. Cows were healty, milk production was quite high (fot that day) and we were producing more milk than the country could use, resulting in a price of around $3.00 per hundred weight. That's why a lot of those farms went into the soil bank as the farmers got older and their sons went off to seek other employment.
I realize that in later years low moisture corn was put into silos which saw pretty much whole grain corn going into cows. No one around here does that anymore. Now, it's either grass silage being made or sudan grass silage. Still some traditional corn silage being put up, however. Other mixes such as peas and oats are put up but not very much.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tuning-Up Your Tractor: Secondary Ignition Wires and Distributor - by Curtis Von Fange. In our last episode we spent the entire day checking out the spark plugs. Is that efficency? Actually, it took more time to explain than it really did to do the inspection. At any rate we decided that a compression test was in order so we could verify the internal engine status. That way we wouldn't buy any tune up parts until we were sure that the engine was in reasonable mechanical condition. Our tests showed a fictional compression reading of 85, 80, 82 and 86 psi. That is well within a
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
