Posted by Tom in TN on September 28, 2021 at 19:10:20 from (172.58.86.204):
In Reply to: Re: new Ford plants? posted by jm. on September 28, 2021 at 18:31:22:
jm,
Are you familiar with the town in Tennessee where Ford announced that they are planning to build their assembly plant? I'm not, but I searched the internet for the town (I think it is named Stanton?). The town has a population of a little over 6,000 people. It's a goodly distance from any decent sized town. I can only imagine the logistical/infrastructure problems they are going to have to resolve. Where are the new employees going to come from, and where are they going to live? Who's going to build the schools necessary to teach the kids that come with their parents. Is there ample electrical and sewage capacity for the plant and for all of the residents?
I'm sure they can work out all of the challenges, but it seems like a daunting task to me.
Tom in TN (near Spring Hill with the gigantic GM plant)
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.