you need to find a new hydraulic shop. i don't know the diameter of your cylinder rods, but today i bought 10ft of chrome 1045 rod. it was about 2.00 a foot i believe. at that price, why would anyone rechrome a small diameter cylinder rod? i can understand rechroming/grinding a 1000 dollar rod if it wasn't bent, but not a small diameter rod. same time i bought the rod, i bought a couple 3 in polypac piston seals, and some gland seals. i believe the total for them was about 30 bucks. i won't see a bill until the end of the month so i apologize for not being more accurate with my prices. i understand a hydraulic shop has overhead, and need to make a profit but those prices seem way out of line to me. good luck with your project.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Operator Safety - Loader & Backhoe Operation - by Staff. Loader Operation Do not transport anyone in the loader bucket. Always carry the loader bucket low for maximum stability and visibility, whether the bucket is loaded or empty. Always use the recommended amount of counterweihting to ensure good stability. Be careful when handling large objects such as round bales, logs,
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
