Posted by Janicholson on August 13, 2021 at 06:18:31 from (24.240.46.228):
In Reply to: Oil Pressure Question posted by Jeff NWOH on August 13, 2021 at 05:25:40:
There could be a design feature of that engine allowing that pulsing. I would get info from a dealer service tech first. Ticking pressure reading in time with RPM is a very bad sign (opinion). As you surmise, a failed bearing oil passage alignment with pressure. Depending on the owner's wishes either fill it with 15-40 oil, and see how far it gets before failure, or rip into it now. Find a bearing set before ripping into it. I have seen it several times. In one instance the tractor lasted for 5 more years, sold and gone. Another lasted 8 minutes, but began pounding at 4 minutes and was shut off. Others disappeared into the future away from me. Jim
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Good As New - by Bill Goodwin. In the summer of 1995, my father, Russ Goodwin, and I acquired the 1945 Farmall B that my grandfather used as an overseer on a farm in Waynesboro, Georgia. After my grandfather�s death in 1955, J.P. Rollins, son of the landowner, used the tractor. In the winter 1985, while in his possession the engine block cracked and was unrepairable. He had told my father
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
