Posted by Tom OConnor on July 31, 2021 at 07:57:34 from (66.227.129.170):
In Reply to: Steiger tractors posted by SVcummins on July 30, 2021 at 12:25:38:
I had the first 325 that came into the State of Michigan and it was a big disappointment. The three gear planetary hubs had to be changed out to the five gear hubs at a cost of over four thousand a corner. The old ones would get hot enough you could fry eggs on them. Next the banded duals were hard to keep tight and would easily load with dirt between the tires if you hit a spot that was too wet, the air conditioning system was only a touch better than nothing at all, the hydraulic system was inadaquit in volume and pressure and the clutch was a dry clutch and had to be always be engaged at idle and the implement out of the ground. The engine was a 325 horse Cat 3406 and was as good the day I sold the tractor as the day I bought it.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Threshin Demonstration - by Michael Delaney. Introduction I bring you greetings from Prince Edward Island, Canada. We are Canada�s smallest province but big on farming. Maybe you�ve heard of us. Potatoes are our biggest crop. However, there is lots of mixed farming here also. I have a small mixed farm with 25-30 cattle. I make very good use of old machinery. I have a 135 MF Diesel, Farmall H and 1/3 share in an Allis B. I have complete lines of tillage and harvest equipment, and a saw gear etc. I have everything one would
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
