Posted by Jim.ME on July 14, 2021 at 10:08:28 from (67.242.178.40):
In Reply to: Leaking tire valve posted by super99 on July 13, 2021 at 17:42:09:
I just want to clarify some terms here for future readers, because I have seen good core housings thrown away when just changing the core in the rescued core housing solved the problem.
super99's picture is a core housing, not a core, not a stem. It is used in a liquid fill valve stem (either on a tube or in a rim). There is a common valve core inside that housing that can be changed. The core housing does not normally need to be changed, in my experience the core is the most common leak. In super99's case the core housing did need changing as the end of the housing (opposite the threaded end) should have had an O-ring in a groove, which seals inside the valve stem. As he said the end was broken off, so it lost that seal in the stem.
A tire shop that services ag or construction tires should have core housings readily available. TSC and other farm stores usually have some if they have a Slime display. The core in the housing is the same core used in auto valve stems, easily found and replaced.
brentb, you must have a serious boat trailer to have had that same problem. While I know it is not impossible, I seriously doubt you have liquid fill valve stems on a boat trailer tire. I would sooner believe a broken metal valve stem on a tubeless tire.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Sunday Drives - by Cowboy. Summer was finally upon us here in Northern Maine. We have two types of industry up here, one being "Forestry" (Wood Products) and the other "Farming" (Potatoes). There is no shortage of farm tractors and equipment around here! I have been restoring old Farm Tractors for the past 6 years, and have found it easier and less expensive to hit all the auctions and purchase whole tractors for parts needed. My wife who works at a local school, and only has weekends and summers off, while on t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
