Posted by Goose on July 10, 2021 at 08:48:59 from (166.181.84.203):
In Reply to: How to heat my barn? posted by Dave BN on July 10, 2021 at 05:11:06:
I can't remember all of the details, but a local fellow once heated a shop with a hot water heater circulating hot water through a large automotive radiator set in ductwork with a large fan blowing air through the radiator.
That being said, insurance companies have a right to be concerned about wood stoves. When I was doing insurance inspections it was unbelievable what I ran into that people had cobbled together for wood stoves, even in their residence let alone a shop.
Whenever I ran into a wood stove, I was required to fill out a separate two page report on just the stove, along with copious photos. The first question on the report usually was, Is the unit approved by Underwriter Laboratories? If it was, I needed to photograph the sticker that said so. If the unit was UL approved and properly installed, there usually wasn't a problem. It's when people got creative on their own that problems come up. I never ran into an insurance company that would insure a building with one of the wood stoves made out of two 55 gallon drums.
And I dealt directly with underwriters at the insurance companies. Local agents are too prone to look the other way on an issue that might get a policy cancelled 'cause if a policy is cancelled their income decreases.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Product Review: JB Weld - by Staff. JB Weld is basically an epoxy glue that does an exceptionally good job of bonding to cast iron and steel along with several other materials. As I mentioned, it is so common that I have yet to buy a tractor that did not have JB Weld used somewhere. It is sometimes used so well you can't tell its there and other times used as a sloppy quick fix. Finding where and how it can be used correctly is key to whether you are using it as an "inelegant hack" or an integral solution to difficult and expens
... [Read Article]
Latest Ad:
1945 Farmall wide body gas with pto and front plow. Runs good but needs new points.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.