The D-2 is not the best model Cat. the roller frame is held in line by that shaft you see in the middle of the roller frame. When the bearings get loose the roller frame will wander out of alignment from the front idler running the track off. Dad's D-4 has an arm going back under the tractor with bearings and they hold it aligned better and more durable. For driveway grading you either want a tilt and angle blade or just buy an old grader. The grader will angle and tilt to keep the crown on the drive so the water drains off. If not crowned water will set then you get holes with water setting in them. You do have to be smarter than the dozer to run them. I never had a sliding issue with one using it. did lots of dozing on the farm filled 2 wet swamps with them 40 years ago. Would push clay out till the front would just start to tip a bith then back up for the next pass. push out the muck in summer and fill in fall and early spring. Filled 3 feet. Push topsoil and muck back over top.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - Tractor Engine Repair - by Teri Burkholder. One of the great things about working on a tractor engine with your other half is that you know what he is thinking of at all times and can anticipate his every move and his next thought of what he will do. With Ben, anyway, I can tell! He'll be busy working and I�m handing him tools and he says, "give me that..." and I�ve already got it in his hand or "hand me that....."and I�ve got the portable light right where he needed it placed to see. "Run in the house and get me a...."as I open th
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
