Well maybe that is because the term is so misused. I don't see hoarding, and stock for prepared living as anything close to the same thing. We have a few iron piles that have not been scraped out in over 50 years. No it is not pretty but sure does supply a lot of parts for different jobs over the years. The iron changes as things change. SO I suppose canning and storing garden staples for winter is hoarding buy your definition. I just call it being prepared for winter or use after that if needed rather than worrying about no gas for a few days or if the one tractor doesn't start and I have hay down I can just go get a different one. Yup we do have a few that are not in running condition we could either fix or part out for a couple other tractors too. SO I suppose that is hoarding too. I don't it sucks to be you. As for the state coming in and removing property from private land is none of their business what the guy has. I'd be pissed too. IF i had to put up with state over reach like that I'd probably leave that state. Yes I've considered leaving where I am to someplace else. And under the new bolshevik regime It might be better in Russia.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Massey Ferguson 35 (and up) Tractor Assembly Notes - by Jack Wetmore. These assembly notes are for Massey Ferguson tractors with a two stage clutch and 6 speed, 8 speed and mutli-power transmissions. I see a lot of discussion forum messages regarding damaged clutches from improper assembly. The objective is to have the engine and transmission slide together safely and easily until the gap between the two halves is less than 1/4", BEFORE tightening any of the bolts holding the two together. Using bolts to draw the two halves together will damage the PTO
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
