I can't answer your question about drying lumber but. You & your sons may want to give some serious thought about what you are trying to do. I have built a new house every year for most of my life. The first when I was 19 & I'm 67 now. The only lumber you will be able to cut yourself & POSSIBLY save money on is your studs, floor joists, & rafters and you better have some really long & really big trees for your rafters & floor joists. You will still need to buy your sheathing for your roof 4'x 8' & your outside walls 4'x9'. You will need to buy 4'x8' 3/4 tongue & groove sub flooring. You will still need to buy your interior trim boards. (unless your are building a rustic cabin) Don't forget about your green treat for your sill plates. You also want perfect stair treads & toe kicks. We haven't even talked about kitchen & bathroom cabinetry. So unless you have access to some really big, really long trees all you are saving money on are your studs & you sure don't want to have one of your studs warp or twist in a doorway or after you are done dry walling. I'm not condemning what you are doing as some of these lumber costs are scary. I'm just saying give it some serious thought as to what sometimes seems like a good plan doesn't always turn out that way in the end.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that�s wha
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
