Wasn't easy to line inside with concrete. I made two cutouts where the 4 bung holes were. Ran re bar long wise in 6 places. Put 2 2x6 every 60 degrees. Made one pour at a time. After 5 pours, I formed up the ends and middle and poured the ends and middle. Last pour capped off the last side. Spot welded metal where I made 2 cutouts to gain access to inside tank.
I put pipes between the 2 hollow parts so water could get to both sections. The concrete held each section together
That was one of my first retirement projects. It's worked for over 15 years. It can turn white rock on a sidewalk to flower.
It's complicated to explain. Took me a week do do. I wasn't going to give up just because a 500 gallon fuel tank wasn't make of heavier metal.
Fixupper had better tank to work with. He's the winner.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors, A Woman's Touch - by Teri Burkholder. I thought I would give you a little background on how I got myself hooked on tractors and their restoration. My family is a very "crafty" bunch of people. By crafty I mean good with crafts!! My Dad is a retired industrial engineer from Bucyrus Erie which made big shovels for excavating and he is also a wonderful wood worker. My mom and my "guardian angel" has had her own ceramic shop for 30 years and is an excellent painter. With these skills always active in our house it was hard not t
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
