Posted by Determined on April 30, 2021 at 16:39:51 from (216.130.212.201):
In Reply to: Funny shop stories posted by 37 chief on April 29, 2021 at 20:40:08:
Back when I had the shop every now and again one of the mechanics wives would call during the day, sometimes a problem with one of their kids or whatever no big deal as long as the calls were brief.
One mechanic his wife would call for him quite often, I would open the office door and holler to him that there was a call for him.
His typical response was who is it?
Like I said I had no issue with occasional calls but don't expect me to be your secretary.
Finally one day when his wife called asking for him, with the phone receiver sitting on the desk I opened the door to the shop and hollered out Mark phone call for you to which he hollered back who is it?
I hollered back I don't know if it is your wife or your girlfriend and I don't want to make that mistake again.
Coincidence maybe but he never again asked who was calling for him.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.