Posted by Janicholson on April 24, 2021 at 06:17:36 from (24.240.46.228):
In Reply to: Why metal poles 2? posted by Geo-TH,In on April 24, 2021 at 05:43:57:
There are at least 5 different voltages in the image you provided. I don't think any are connected together. The far right pole has the lowest voltage on its lowest wires running from right to left, and supported by the (appearing) tallest single pole with the sign on the bottom. it probably runs 2 to 4000 volts. On that right pole is also the next level on its top cross arm, could be 8+ thousand volts. It goes out of the image away and to the right. The next level is the 6 conductors on that tallest (appearing) pole with the sign. maybe 20,000ish. The next is the double pole three wire also going away in the image. Maybe 80 to 120Kv. and last is the actual highest towers using angle iron open structure. they probably carry 500K to 750K volts. that confluence of wires is nasty. There remain large coal deposits in the area that range from the former Snow Hill underground mine, to the Peabody stripping south of Seelyville. My mother's cousins mined there in the 40s and 50s with the walking draglines. Jim
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Massey Ferguson 35 (and up) Tractor Assembly Notes - by Jack Wetmore. These assembly notes are for Massey Ferguson tractors with a two stage clutch and 6 speed, 8 speed and mutli-power transmissions. I see a lot of discussion forum messages regarding damaged clutches from improper assembly. The objective is to have the engine and transmission slide together safely and easily until the gap between the two halves is less than 1/4", BEFORE tightening any of the bolts holding the two together. Using bolts to draw the two halves together will damage the PTO
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
