With a 730 in todays world,you most likely dont have a tremendose amount of ground.A 12 ft ft will serve you well. Yes you could probably pull a bigger. But it's not a contest to see who can pull the biggest disk.Easy pulling a 12 ft in 4th or fifth gear is a whole lot better than pulling the guts out of it in 2nd or third with a 14 ft or bigger.Then you have wheel slippage to deal with.Nobody said a word about that.Duals,fluid filled/weighted;dry... are all factors.You may have the 'ponies',but you may not have the traction.Also depends on how deep. to the spools,or letting the wheels carry it some.Go ahead and buy a 14 or 16 ft. But in the long run,12 ft will be best.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Dad's Old Silver King and Joe Capalco - by Woody E. Diehl. My father, Charles Diehl, grew up in the Elsworth, Ohio area during the Depression on a small working farm. I never saw the place, nor was I around during his early years. What I know about those hard times comes from listening to Dad and his old pals reminisce from time to time. One of the old timers that would sit with Dad and chew the fat about the 'good ole days' was Joe Capalco. Joe wasn't like most of my Dad's friends. He rarely worked that we knew of. Always had plenty of time
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
