Posted by Vincent C on February 25, 2021 at 07:18:39 from (216.57.72.154):
Hello all!
Its been a struggle to get this old baby running to perfection again. Replaced the points and condenser because it stopped firing. I did not change any of the magneto positions as I understand the issues with that.
Once reinstalled I cannot get it to fire on #3 plug. I have a book, but it references several models and firing orders without describing the different models. We do not see a way to time this baby even though they talk about using a timing light in the book.
This distributor Is the one that sticks straight out and into the oil filter and doesnt take a turn. We have lined up the flywheel to TDC and the hatch mark through the inspection hole on the magneto in several positions thinking it was inserted a tooth off with no relief. One tooth up or down it wont fire at all.
Even though there is a slot at the bottom bolt hole that magneto does not adjust.
If anyone has encountered this problem before we would appreciate your input.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Running Beans in East Central Indiana - by The Red, John Fritz. Fall is my second favorite season behind the long days of summer. The calendar reads late September and it�s time to start running beans. This article is about my experiences helping my farm neighbor Ernie Swoveland, along with his grandsons Jeff and Craig Ring, with the soybean harvest in East Central Indiana for the 1999 season.
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
