Skid steers are good machines for snow work up to a point. For Your situation a decent size skid steer would work. You cant see much behind you with a skid steer, I would recomend a back-up camera As I mentioned you may want a snow pusher attachment for either a tractor or skid steer.They are wider than a loader bucket and much faster as they are open on the bottom and you dont lose time dumping the bucket.Most newer loaders and skid steers have quick-attach feature so you can switch the attachments easily. You shouldnt need chains on a skid steer or 4wd tractor with ag tires.If you get turf tires you may need chains. A skid steer will tear up grass if you do much sharp turning. The reason I asked about insurance is because liability for snow removal has become very expensive due to slip and fall claims. Your contractor probably has a pretty high insurance bill between liability and workers comp insurance. Many times commercial plowing contracts stipulate a certain amount of insurance and the contractor has to provide proof of meeting the insurance requirements. You are in an area that doesnt get a lot of snow but also a high cost of living area which affects the cost of the plowing. As mentioned you could always put it out for bid and try to get the word out so you get several bids. As I mentioned before, they could look into renting a machine for the winter instead of buying one. That way they wouldnt have such a big investment if it didnt work out. Where on LI ? I had relatives there at one time . I am in central NY south of Syracuse. We average 130-140" snowfall per winter, although this one has bee light on snowfall till this month.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that�s wha
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
