Posted by used red mn on February 15, 2021 at 23:05:25 from (75.73.112.20):
In Reply to: More feed grinding... posted by coonie minnie on February 15, 2021 at 17:33:46:
Back in the day on the farm in KS, if I remember right we had a 357, I know it had the larger mill which I think was a 21 in. I think the small was 16 in. It also had the larger mixer like that one looks to have. The tank cone is nearly 4 foot in diameter at the bottom and inside is another mix cone that turned with the vertical auger. When that tank was nearly full it took a fair bit of power to turn it. We used the Farmall M I now have on it most all the time. When that tank was near full there wasnt much left to power the hammer mill. The old M spent quite a bit of the time on that thing with the governor holding the carb throttle plate wide open. Quite often that was my after school job to grind a batch of hog feed. We farrowed in a 17 sow house, with 3 sets of sows a year. We would fatten out all the pigs produced, which counts up to quite a few with 10 - 15 per litter. Later they bought one with a smaller mixer, that one a Farmall 300 could run in a pinch.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
