Posted by Carls70 on February 15, 2021 at 19:37:06 from (172.58.83.132):
In Reply to: Hydraulic clutch posted by RLP in Co. on February 15, 2021 at 11:26:39:
All liability and resale considerations aside, a word of caution: most of the hydraulic clutch systems I have seen use brake fluid. I would not want to mix fluids or mess with the steering. If you are determined to use the existing vehicle then I would seriously consider a 12 volt linear actuator. I would think that you could mount a bracket on the bottom of the dash and put some type of a slotted bracket or clevis over the clutch pedal arm for the actuator to push against.
A quick Amazon search turned up an actuator that will push about 225 lb with a 6 inch stroke that travels approximately half an inch a second and draws about 3 amps at 12 volts. https://www.amazon.com/dp/B07RXQGJLT/ref=cm_sw_r_cp_apa_fabc_F0681GVNHXA8RCQ22VA1
I think a spring loaded center off type switch (DPDT momentary) plugged into the cigarette lighter and fastened to the end of the shifter would be easy enough to use with your shifting hand. You would bump the switch or hold it down to move the pedal up or down and release the switch to stop moving the pedal in a given position. The actuator has internal limit switches to stop when it reaches the end of its stroke so I would try to set the travel geometry up so that the actuator travel has authority over the full clutch pedal travel without trying to push the pedal through the floor or pull it back past its engaged stop.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Show Coverage: Godfrey, Illinois Country Days - by Cindy Ladage. Except for last fourth of July's Old Gold show in Springfield, Illinois, I don't remember when it was so hot. Nevertheless, the heat didn't keep vendors and visitors alike from enjoying the third annual Country Day's Event. Jane Elliott said the event was originally a one man show. "Barry Seiler, owner of Country Town Farm Supply store used to invite people up to the Johne Deere store. He would give hats and a free meal for everyone that brings a tractor." Elliott said while this
... [Read Article]
Latest Ad:
one 8n and one 9n tractor. totaly restored,pretty much everything is new. one 6ft blade good shape.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.