Why not go to a Plasma cutter and forget the torch unless you are junking out a lot. For fabrication the plasma would be a cleaner cut with less gas and bottle cost. Some even have their own air compressors for the air. Will cut 1 inch wit some of the bigger ones. The up front cost will be more. I think the over all cost will be about the same in the long run. I've got a don't remember with propane. It is not quite as hot temperature wise but will heat and cut the same. Does use a different tip for the propane than for acetylene. If I had to by again I would get a plasma as fast as they will cut the time savings if doing a lot of cutting is worth something. Also don't have to wiait for it to heat the spot to star cutting on heavier material. Just pull the switch and off to the races. Yup tips will need changed and probably faster with the learning curve. Torch tips will probably be similar during the learning curve too. Get a tip cleaner with it to keep the holes open in the tip. splatter from burning hole will plug them some times if not careful and even if you are.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Sunday Drives - by Cowboy. Summer was finally upon us here in Northern Maine. We have two types of industry up here, one being "Forestry" (Wood Products) and the other "Farming" (Potatoes). There is no shortage of farm tractors and equipment around here! I have been restoring old Farm Tractors for the past 6 years, and have found it easier and less expensive to hit all the auctions and purchase whole tractors for parts needed. My wife who works at a local school, and only has weekends and summers off, while on t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
