Posted by Steve@Advance on January 23, 2021 at 12:27:02 from (66.169.147.211):
In Reply to: Diesel fuel smell posted by bc on January 23, 2021 at 08:47:29:
Just working in the same room with the kerosene heater will make you stink, rep;ace it with propane.
And get rid of the diesel in the parts washer. I gave up on a home parts cleaner, it was too expensive! Put in $50 worth of solvent, use it once and it's evaporated. A real Safety Kleen machine is only available to corporations and the ultra rich!
Now I get by with Purple Power, oven cleaner, spray carb and brake cleaner.
I haven't found a way to neutralize diesel smell. It just has to wear off. And no way to avoid it completely, especially working overhead with it pouring down your arms and splattering off the floor.
It seems to wash out of my clothes though. At least I never notice it when I get them out of the closet. To me diesel is no where near as disgusting as cigarettes! When my ex smoked it was in everything, especially the clothes and towels. Nothing like getting out of the shower and drying with a towel that smelled like cigarettes!
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Grain Threshing in the Early 40's - by Pat Browning. The setting is rural Wisconsin, halfway between East Troy and Elkhorn, on Hodunk Road, our nation was at war, and I was 6, 7 and 8 years old. George was our "threshing neighbor." He was the one with the threshing machine, a JI Case on steel wheels, and he pulled it to our farm with a JI Case standard tractor also on steel. In those days, steel wheeled implements were common. The roads were general gravel, so the lugs cutting into them wasn't a problem. George would set up the thresher, s
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
