better description: 1/3hp ac motor with a 4" grinding wheel bolted to a 3/4" plywood just bigger than the motor base and lout to about an inch from the motor side of the wheel. I put a quality door hinge on the Wheel edge of this plywood. I used a second piece of plywood with the same size attached to the hinge. Under that I put 2 1X1" hardwood square "runners" parallel with the shaft, and far enough apart that the bottom plywood was almost touching the shaft to be ground. I put a wood wedge at the back edge of this setup between the wo plywood pieces to tilt the motor and grinding wheel downward against the shaft to be ground. I used a small vice grip to hold the two plywood pieces together against the wedge and two long hose clamps to hold the bottom plywood against the shaft Moderately tight to keep it from being loose, but allow rotation on the axis of the good part of the shaft. I also used a wheel dresser to taper the wheep to the approximate angle of the shaft surface. A cone shape at the outer edge. I hope this made sense. Jim
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: Winterizin Engines - To Drain or Not to Drain? - by Staff. Another great discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: "Winter is fast approaching..for a gas tractor should the gas tank be drained and run the engine til the carb is dry or do the gas stabilizer products I've heard of work? (tractor will not be used til spring) any other tips for winterizing?? "
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
