I didn't read all of the replies, and it surely has already been mentioned, but we have dribbled our low performing well into a cistern for about 30 years. I have a float shutoff valve in the cistern to keep it from overfilling. It requires a shallow well pump to pump water FROM the cistern. I have the cistern input flow from the well shut down to just faster than a drip - I call it a dribble. It keeps the 2000 gallon cistern full. It's trouble free - I rarely have to even glance at it. Before we drilled the well, we had a natural spring that produced about 300 gallons per day. I used the same setup on the spring, but I also had a sump pump switch rigged up that would break power to the spring pump when it was close to cavitating. It also worked flawlessly for many years.
You probably already know this - they make a $20 pressure switch that will kill power to your pump when the system pressure drops below about 20 psi. The bad news is you will have to manually re-set the switch every time it trips. I personally would not want my deep well pump using the heat limit switch to regulate its operation. I see how it would be convenient in that it re-sets itself, but the thought troubles me. . .
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Memories of an IH Super A When I was ? up to 10, I worked on my Papaw's farm in Greeneville, TN every summer. As I grew older (7), it was the thrill of my day to ride or drive on the tractor. My Papaw had a 1954 IH Super A that he bought to replace a Cub. My Papaw raised "baccer" (tobacco) and corn with the Super A, but the fondest memory was of the sawmill. He owned a small sawmill for sawing "baccer" sticks. The Super A was the powerplant. When I was old enough (7 or 8), I would get up early and be dressed to
... [Read Article]
Latest Ad:
one 8n and one 9n tractor. totaly restored,pretty much everything is new. one 6ft blade good shape.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
