Posted by Adirondack case guy on November 28, 2020 at 17:24:07 from (74.76.16.33):
In Reply to: Delivery trucks posted by svcummins on November 28, 2020 at 15:38:37:
When CASE introduced the Case-0-Matic 100 series tractors they offered a promotional program to dealers where dealers could by trucks like that one from Case or they could go to their local car/truck dealer and buy a new truck and Case would give them a reimbursement. CASE also had complete decal sets available for both cab-overs and conventional trucks. Dad went to the local Chevy dealer and ordered a new Cab-over chassis with 292 six and 4 speed. He ordered a new Swartz tilt bed body for it and painted and decaled it like in the picture. He didn't opt for the under bed tool boxes and flaring though. The truck was badly under powered and under geared for our area, and after he blew a hole thru the side of the 292, he ordered another Chevy 60 series cab-over. It was a much heavier chassis and had a 427 with 5 & 2 trans and rear. We remounted the Swartz body onto that truck. As cab tractors and big 4X4 tractors became popular, I bought a used transtar SA and 220 Cummins with 10spd ranger to pull a Swartz single drop trailer with a hydraulic tail. The 60 Chevy got replaced by a Louisville L9000 with a 6-71 and 10spd, and the old Transtar got updated to a newer one with 318, air tag axle and 15spd, still pulling the 40' Swartz trailer.-----------------------------Loren
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Farmall Story - by Ed Meadors. The year was 1978. Our young family had recently moved to rural Chesapeake, Virginia to a plot of land which would finally allow us to realize our dreams of a huge garden, critters and more lawn and pasture than we would ever use! We needed a TRACTOR; not a riding mower or tractor wannabe, but a real TRACTOR. The answer to our needs materialized in the form of a '44 Farmall A, complete with cultivators, discs, single plow, a 5ft.Woods belly mower and one, mounted spare 9.00x24 rear wheel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.