Someone mentioned a Montgomery Ward hammer mill a little further down the thread. I don't know who made them for Wards, but we had one when I was growing up. It was a great mill. We had several screens for it but only used the 1", 3/4" & sometimes the 1/2". The screens were easy to change,the "blower & dust collector" worked great, but the thing we liked best was the feed table. It had a "chopper" head that was fed by about a 12 or 14 inch wide belt that was about three feet long. It was controlled by a speed clutch. If the mill's speed slowed, the table stopped & as the mill's speed increased, the table moved forward. You could never plug the mill using the feed table. (I know, because I tried many times.) It worked great for alfalfa hay and ear corn. It sat by a 1,500 bushel ear corn crib that was emptied every year, for many years, through that MW mill. I know, because I dumped thousands of shovels full of ear corn onto that feed table. I don't remember that it ever broke down. I think we did turn the hammers once.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Little "M" - by Donnie Anderson. They call me "Little M" and this is my story. For the past several years I have sat against the tree-line, where my parts have rusted and rotted away. For all of these years I have wondered just exactly what happens to old tractors? Times were not always like this. I can remember back to 1948 when I was a brand new John Deere Model M. A man and his wife came to the dealer and looked me over real good. After many talks with the salesman a deal was struck and I, along with a M2 plow, c
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
