I've read all the comments below and I have to say. There is no more stress on the hydraulic system with the arms raised or a cylinder holding up an implement when it's parked than there is with the engine running. The same stress is on the hydraulic circuits holding the implement up when the tractor is running or when it's not running. Either way the hydraulic system has to build enough pressure to raise the implement then hold it up. Yes I believe having implements raised and parked is a very big safety issue which is called Kinetic Energy. Yes if parked and the implement is down and some one has moved the control lever to the raise position then the implement raises when engine is started is a safety concern. But we had a rule around home years ago, no riders and stay clear of equipment, because mounted implements just don't trail behind a tractor they can move side ways when the tractor is turning. I was teaching my 11 year old nephew how to drive my zero turn mower a few years ago and had to teach him about tail swing. Then he was digging divets in my yard each time her turned around. I told him to slow down when turnning around. His reply was, "I do it this was on my video game"... I told him his not playing no dam video game.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: The Pefect Collection - by Staff. Another neat discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: " I thought it would make for some interesting discussion for many of you to post what would be considered your dream or perfect antique tractor collection of five tractors, assuming room for storage and cost were not a factor. I have posted my "Perfect Collection" on the Farmall board. List any brand preference but keep
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
