Posted by cutlass1 on November 08, 2020 at 04:52:06 from (67.245.198.210):
Hello, We have an issue with our Ford 4610. Motor cannot turn by the crank bolt but it can turn slowly with great effort with a pry-bar on the flywheel teeth. Oil pan was dropped and there was no indication of engine damage, the crankshaft had thrust play and connecting rods had normal endplay. All gears appear to be normal. No damage to the valve train. I wasn't present when it locked up, but the person who was said they heard a strange banging noise out of nowhere and they shut it down. Afterward the starter could not turn the engine. I was able to see the clutch fork engage the throwout bearing but the motor still can't turn easily when clutch is pushed down. I'm thinking there might be something stuck in the flywheel area. I heard that "headland" pistons would come apart but I don't see any indication of damage on the cylinder walls or pistons when looking up from the bottom of the engine. Anyone had an issue like this with these 3 cylinder diesels? Thanks
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
