Posted by BarnyardEngineering on October 28, 2020 at 07:38:08 from (98.17.202.246):
In Reply to: Tractor sizing help posted by Countrybimm on October 27, 2020 at 15:30:21:
Nobody that does custom work is going to want to bother with a piddly 80 acres, and likely does not have any equipment small enough for the fields.
Only get a huge tractor like the ones mentioned if you can get them CHEAP.
Just because you have a 150HP tractor for example, does not mean you need to buy 150HP equipment. Say your tractor is rated to pull 7 plow bottoms. Get a 5 bottom plow. Say your tractor is rated to pull a 32' harrow. Get a 24' harrow.
Match the equipment to the field. The tractor will pull it.
One advantage to being overhorsed is you won't be putting as much strain on the tractor by pulling smaller implements, and the tractor will be less likely to break down under the lighter loads.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.