There are cases were its not about what brings the most money labor saving ect, its whats easy and practical for the user. I worked at 3 different horse farms, thoroughbred boarding and breeding farms, were i kept my horse and the other farm which had upward of 2-300 horse used small square bales, the other nit wit i worked for less then 2 years used big squares, a pain to feed in the stalls.
Second and 3rd pic are what barns look like from the outside, first pic is the view looking down a 40 stall barn, 20 stalls each side, you drive straight threw with the tractor and dump wagon to clean the stalls, the mares and foal were bedded on straw, so night crew would stack straw 2-3 bales high on one side of the shedrow behind the stall door, hay would go on the opposite side of the row, and shavings dumped in center when needed, no way to use round bales in a situation like this, small squares were just easier to deal with.. i laugh at the guys who call them idiot cubes! My friend who used to milk cows in a tie stall barn also put up small squares, about 7000 in the mow above the cows, we would slide open a door in the floor and drop down the hay in the center isle to feed to the cows. There was no way to get a round bale into his barn either. Here we have accumlators, bale baskets, bale stackers ect, i just use a baler with a thrower and rack wagons.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.