Posted by flying belgian on September 20, 2020 at 10:42:00 from (216.114.232.240):
Okay. More on my septic drain field. Had the truck come and pump the tank. It was over full of solids from my not having it pumped for last 6 yrs. Driver said that left solids get around baffle and flow out my drain field and plug it. He did an excellent job of rinsing and completely draining my 1000 gal. tank. So I now have about a month to figure out what to do. My drain field tile is only covered with about 4" dirt. Some places maybe 6" dirt. He said not only are holes in pipe plugged but also the pores in the gravel or whatever type media they used back in the day are probably also plugged. There is just wife and I living in this house anymore so not to much water use. Do you think I could make a 20" long drill bit and drill through the 4" cover dirt, right through top and bottom of 4" tile and then down through gravel? Do this about every foot on both the 150' tile lines. What size bit should I make? I don't want dirt to wash into the hole I drill on top of tile. Would 1/2 inch be to big?
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Day Mom Drove the 8N - by Brian Browning. My Dad was wanting to put in a garden but couldn't operate the 8N and handle the old horse drawn plow he had found and rigged up to use with the tractor. Well, he decided to go get Mom out of the house and have her drive the tractor while he walked behind the plow. You got to understand that while my Mom is a hard worker who will always help whenever she can... she had never operated farm machinery before that day. Dad got her out there, explained how the clutch was the same as in our o
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.