Posted by Steve@Advance on September 13, 2020 at 14:39:55 from (66.169.147.211):
In Reply to: oil plugs posted by cb in wisc on September 13, 2020 at 09:39:49:
I've done it to garden tractors to get the oil out in the open so it doesn't drain on top of the frame. Not a valve, just a pipe extension and a cap or plug.
Some skid loaders come factory with a hydraulic hose and a cap you pull out to drain. It's a necessity because of the bash pan under the engine.
Every application would be different, depending on the type drain plug used and the location. If there is a sheetmetal oil pan with a gasket type plug, I would be hesitant to try. Not much to work with, too weak support the extended leverage and vibration, could crack the metal.
But for a cast pan, as long as there was no danger of it getting knocked off it should not be a problem. I would use a ball valve and just for safety, plug it.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford Super Dexta - by Anthony West. The rusty blue tractor caught my eye as my truck zipped by the farm implement business. It looked so fornlorn amongst the lineup of newer equipment. But it was just the right size for my small farm. I stopped in and asked the proprietor for further information. "It's a 64 Ford Super Dexta", he said. "It's a tough little tractor, although it's a hard starter being a diesel and all." He did manage to get it running, compliments of a can of ether. Once started it putted along pretty good. It
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
