One big pan under the discs shares oil all the way across, the gears all spin in that pan of oil. If you mow on a good hillside all the oil runs to one end. The gears tend to carry the oil back up again and get oil, but the upper side will eventually get a little dry. The manuals on these have recommendations of how long to go before leveling the bar for a couple minutes to get the oil distributed again; but on a three acre patch you should be just fine. The concern is if you mow road ditches and drive a half hour with the end of the mower up the whole time.
The other design of mower is individual segments, each turtle is driven by its own independent gear set with its own resivor of oil per turtle. These aren�t affected by a slope. But you have a lot more dip sticks to check!
So to answer your question exactly, it is something to be aware of with certain models but a 3 acre field you likely will get the bar flattened out from time to time and not have any issues at all, check your manual but I wouldn�t be worried about it as long as you get the bar level every 15 minutes or so I think is the common recommendation.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Case Farm Equipment - by Jeremy Sweeten. My name is Jeremy Sweeten and I am currently a junior at Purdue University. I am takin a dual major in Agriculture Systems Management and Agronomy. I am from North Central Indiana, Miami County to be exact. My dad teaches for Marion Community School Systems an outdoor lab called Asherwood. We live there to manage the place. They just happen to have a Case 311 with a Triple Range transmission. I grew up mowing, pushing snow, and hauling maple sap with it. In 1986 my parents bought an old,
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
