Posted by John T on August 15, 2020 at 17:52:58 from (45.16.200.171):
In Reply to: Regulator 6 Volt posted by Ted in NE-OH on August 15, 2020 at 17:23:39:
On many 4 terminal VR's (BAT FLD LOAD ARM) the terminal underneath or off on one corner by itself or not labeled is GEN/ARM
GEN/ARM wires to gennys ARM post FLD wires to gennys FLD post BAT wires to load (NOT battery) side of Ammeter (if it has an ammeter otherwise to hot ungrounded battery post or feed source like maybe on a starter switch input where big battery cables attaches) LOAD/LIGHTS feeds hot battery voltage to loads like lights or ignition often to the BAT Input terminal on those switches
4 wire VR's (BAT FLD LOAD ARM) can used or 3 terminal VR's (BAT FLD ARM) can be used and they can be interchanged if wired properly
On a 3 terminal with no LOAD terminal loads wire instead to the Load (NOT battery) side of ammeter
SUMMARY the one underneath or by itself is the GEN/ARM and it wires to the gennys ARM post
If I missed anything the other fine gents can add to this
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The River Tractor - by Charlie English Jr.. This is a 4010 John Deere that was used to farm on the Diamond Island which is in the Ohio River about 15 miles southwest of Evansville, Indiana. About ten years ago, this tractor was parked close to the bank as the river was washing the bank of the island away.
... [Read Article]
Latest Ad:
Wanted to buy model 65 massey ferguson 65 diesel
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
