What you really need is a ROME disc. They will CUT roots , BUT the down side to a true Rome DISC is it takes LOTS of power and traction . I have cleared land for highways and the two the company had would make a D 8 H snort and slice thru and 8 inch root and spit out one foot chunks from the ft gang and the back gang split that in half and cut into the ground over a foot deep and take a fourteen foot swipe . A Standard off set like a 10 footer even in hard ground on first pass with the notched blade on both gangs will get down four or five inches on first pass and chop up small roots . tryen to run a moldboard thru stuff like that can become really dangerous , I have snagged roots with a moldboard plow more then once along tree lines and flat up and stood the tractor in the air and it happens REAL fast , Looking down the exhaust pipe inspecting the inside of the muffler or looking only at stars at night can bring on racing strips in your shorts FAST . Next best way is a three shank ripper on the back of a dozer getting down to around 18 inches , or the tillage tool we now use over the moldboard , this is a barnyard creation that someone else did up . Who ever built it took a 9 shank disk chisel and removed the 9 shanks and replaced them with FIVE D M I parabolic shanks with the 7.5 inch tiger points , now here again this takes LOTS of power and traction , even at 14 inches it taken over 200 Hp and all the weight we have and we are still lacking pony power and traction As we can NOT Go up the hills on the flat we are fine and on slight grades Ok . What we need is a true bend in the middle 250 Hp tractor that weighs in at around 30 K . Thrust me this will find roots and ROCK , i have found rocks that have not seen the light of day in 10 million years .
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
