You won�t get a very big hay crop the first year. The oats shades and competes with the hay, making it smaller the first year.
Many folk will chop off the oats as silage, so it is harvested sooner and lets the hay kick into gear quicker.
Another option locally, and I think your area, is to plant oats, harvest it, harvest the straw, and then plant the hay crop in early September (here) so it is ready to go next year. This allows a good oats and straw crop, and the fall hay seeding typically has far less weed and erosion concerns, it will establish well and be growing well next spring. This allows you to maximize both crops, not compromise. You won�t get that hay crop the first year, but you get better oats and a stronger hay crop starting out.
Typically, oats is planted as early as you can get in the field. Even if a little snow is around.
With the hay, you want to moderate that a little bit. Plant when the weather should be pretty good here on out. More so when one would start planting corn, or near there.
Typically you plant 3 bu of oats for grain.
As a nurse crop for a hay seeding, it�s better to plant 2 bu per acre, so the hay gets a little more sun and a little less competition.
Anyhow, that�s how it�s done around here in a cold minnesota type climate.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Torque Wrenches - by Curtis Von Fange. When working with fasteners a torque wrench can play an important role in the correct assembly of critical equipment components. Lets examine in detail some of the reasons for using a torque wrench along with how to correctly use the variety of wrenches available. Applying the proper torque to a fastener accomplishes a number of tasks. First of all correct torque will hold the parts together. This may seem like a trite statement but � think about it for a second. Engineers have designed
... [Read Article]
Latest Ad:
WANTED IH C200 gas engine — complete running motor Wanted complete used IH C200 gas engine in running condition for an International 574 gas tractor. My block has a hole in it and is dead, so a rebuild kit wont do it — need a whole running motor. The C200 also came in the 544 and 674 gas trac
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
