Posted by RLP in Co. on August 02, 2020 at 14:52:55 from (174.254.193.40):
In Reply to: Here we go posted by svcummins on August 01, 2020 at 16:51:29:
I baled about 250 acres of millet with a 3X3 New Holand baler for my boss. Don't remember the model number. I had to fix a bunch of stuff on it. The stuffer box stopped working and the pick up would jam up so tight that it would take hours to clear the jam. The baler had been twisted by someone before me and the door would jam up. I had to cut about a half inch off of One corner of the door. Then it wouldn't tie. I went thru all the adjustments in the book. The needles weren't timed right. The stripper arms had to be removed and bent. I sharpened the knifes with some HF diamond stones. Put a new arm on the bale length arm. It would have cost him more than the cost of a new baler if he had had new holland do the work. Go thru all the steps in the book and it will work like a new baler. Good luck!
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Search For Spares - by Anthony West (UK). Following on from the aquisition of the old Fordson F, I was very much in need of spares. As a novice though I didn't appreciate the fact that there were so many Fordson tractors made, that all the other makes seem rare by comparison. As far as I was aware a fordson was a fordson and it was only through trial an
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
