Posted by Check Break on July 11, 2020 at 18:17:14 from (47.143.124.39):
In Reply to: trailers posted by Farmall 656 on July 09, 2020 at 12:09:56:
Quoting Removed, click Modern View to see
Given you're towing with a half ton, you're a bit limited and don't want the tare weight of the trailer to eat up half your payload. That being said, you want the largest standard brakes you can get. That would be 12"x2" if you opt for 7000lb axles. Forward adjusting brakes will be an option. 7000lb axles come with 16" wheels which enable you to run Load Range G 16" tires (17.5-s if you can get 9/16 or 5/8 studs in your hubs.). Ez Lube style spindles makes greasing bearings a lot easier. Your frame should be at least 6" channel. Length is a personal preference but I can tell you I bought a used 16' Big Tex and wish it was 18'. By considering all your options, you can spec out a trailer that will last you a lifetime for not much more than you'd spend on one without any of the above. Hope that helps.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Massey Ferguson 35 (and up) Tractor Assembly Notes - by Jack Wetmore. These assembly notes are for Massey Ferguson tractors with a two stage clutch and 6 speed, 8 speed and mutli-power transmissions. I see a lot of discussion forum messages regarding damaged clutches from improper assembly. The objective is to have the engine and transmission slide together safely and easily until the gap between the two halves is less than 1/4", BEFORE tightening any of the bolts holding the two together. Using bolts to draw the two halves together will damage the PTO
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
