If the well will flow 10 GPM and not draw down more than 30 ft or so you can run a jet pump from the surface. This would reduce initial costs, and it could be made to be removed in the winter. 50 feet of plastic pipe and a jet at the bottom would not be much to pull. and would allow inexpensive testing of the capacity. Another thought is to use compressed air bubbler type system it is way cheap all you need is 2 hoses (one inside the other is great, or as shown in the video. The air bubbles up from the bottom inside the hose/plastic pipe, and pumps the water with it. It does not pressurize the water at the top, it needs to flow into a reservoir. Almost all railroad boiler water for locomotives was pumped using that method out west during the steam era. I personally knwe a RR employee that was the technician for 35 years, maintaining them. Cheapest setup to get flow rates and determine usability without high $ investment. Jim
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
