Posted by Janicholson on June 24, 2020 at 06:12:37 from (24.240.46.228):
In Reply to: Here’s one for yuh posted by svcummins on June 23, 2020 at 23:14:32:
We are realistically the only place that does't. From history: It was in 1866 that the use of metric weights and measures became legal though not standard in the U.S. and, as TIME pointed out during a later debate over the metric system, some non-metric measurements are actually officially defined by the metric system (a yard, for example, being a specific percentage of a meter). Many industries and sciences used the metric system, and, like Chafee does today, men of the turn of the century—like Elihu Root, Thomas Edison and John Pershing—argued that switching would save the U.S. both money and time. Our lack of a mandate to do it has cost the USA from that point in time. Add together the following: 15/32, 3 yards, one rod, 2 chains, one furlong, .5125", and the width of an H drill bit. Puke. Jim
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - What Oil Should I Use? - by Francis Robinson. I keep seein this question pop up over and over again in discussion groups all over the web. As with many things there are often several right answers and a few wrong ones. Some purist I'm sure will disagree to no end with what I will tell you but most of us out here in the real world don't really care do we ? Some of them only bring their noses down out of the air long enough to look down them anyway. If you are like me you are only doing this old tractor stuff because you enjoy it. You
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
