Posted by MarkB_MI on June 19, 2020 at 23:44:33 from (174.245.16.126):
In Reply to: Wood siding help posted by 37 chief on June 19, 2020 at 21:37:32:
Well, you're kind of limited by what's regionally available and affordable. Here in Michigan, no lumberyard carries redwood, so it would be out of the question.
Western red cedar has good rot resistance, but is a bit on the soft side. It's readily available in most areas as 7/8" boards roughsawn on one side and smooth on the other. I've milled shiplap siding from these to replace damaged cedar siding on my house. (Nobody carries shiplap siding around here anymore.)
I'm a big fan of Douglas fir. It has good rot resistance, probably not as good as red cedar or redwood but it's acceptable for most uses. It's very hard as softwood goes and quite strong. I don't use it much because it's difficult to get here except as 2x4 studs and 2x10 joists. But if you can get it in appropriate dimensions, that's what I would use.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.