Posted by Steve@Advance on June 07, 2020 at 10:53:35 from (66.169.147.211):
In Reply to: Radiator cleanee posted by Plowhand on June 07, 2020 at 09:04:43:
I've seen them too, but can't make a recommendation because I don't have the courage to use them!
I assume this is on a tractor or some equipment that has a brass core radiator. If it's aluminum, just replace it.
Typically a radiator gets clogged with calcium deposits, which require an acidic cleaner to dissolve and dislodge them. Putting an acid that strong through the engine is very likely to cause other damage, like finishing off freeze plugs, causing a seeping head gasket to open up, or finishing off a rust pitted cylinder liner.
If you want to try a cleaner, I would remove the radiator, cap the hose connections, and treat only the radiator. Then thoroughly flush and rinse to be sure the acid doesn't get carried into the engine. When the radiator is back in, before connecting the upper hose, take the thermostat out, run the engine at mid throttle with the hose running in the radiator to flush the block until the water runs clear, then drain the block if possible, reinstall the thermostat.
But, good chance it will start the radiator leaking. If it does, time for a recore (expensive but the best long term fix) or buy a replacement radiator, depending on the size and application.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Fordson F Ignition System - by Anthony West. A fellow restorer contacted me earlier this year asking for some help and advice on a model F that he was restoring. He had over a period of months spent a fair amount of his hard earned cash on replacement parts for the old "trembler" ignition. Sadly though all his efforts seemed to be a waste of time and money as he still couldn''t get the temperamental old thing to run correctly!! If i said that this was a little frustrating for him that would be "conservative" in fact the problem had reduce
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
